Installation:
Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.
Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
CONFIGURATION UTILITY;
Choose COM port, write in desired ISN number, press button Store. Or -
For some ECU s it is possible to read ISN number directly from engine control unit. In this case
select option ECU xxxxx , press Read. Software will try to read ISN. If successful, choose option
EWS emulator and press button Store to save ISN number into emulator.
Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to
DME(DDE) <-> EWS line.
Don t forget to short two starter relay wires (EWS connector)!
Car is ready to start.
In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to
diagnostic K-line.
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.
Wholesale Contact Information
Email: sales@xcar360.com
Skype: uuc050
MSN: sales@xcar360.com
How To Buy Our Products

Product Reviews
Name | Rating | Review |
---|---|---|
Jason (Posted on 2011-11-18) | Great diagnostic tool, works good for my car, thx |
|
Anthony (Posted on 2011-07-02) | Hello, what warranty has it and what is the best price |
2 Item(s)
No Picture! Be the first to Post a Picture of this product! and get Xcar360 points!